ZTE H108N V.2.1 Configuration manual
Page 23 ZTE Proprietary and Confidential
Select Visible to allow your network to be detected by
your computer or any other computer. Select Invisible
and it will be harder to connect to your network
because the SSID name is not broadcasted.
Select the country from the drop-down list. This may
change the number of wireless channels available for
WiFI (Spanish law allows up to 13).
This setting applies only for WiFI N of 40M. Choose the
main channel location as Upper or Lower. For
example main channel 6 “lower”, will be occupying also
channel 10 as secondary (thus 20+20). Select this to
avoid interference with neighbors’ WiFI.
Select the wireless channel from the pull-down menu.
Automatic mode will try to avoid interference with
neighbors’ WiFI. Otherwise to make a smart manual
selection you can view the free available channels with
scanning programs as inSSIDer.
Select the appropriate 802.11 mode based on the
wireless clients in your network. It is recommended to
keep it as default.
Select the appropriate band of 20M, 40M or 20M/40M
according to your subscribed broadband service. If you
are in a dense neighborhood, selecting 40M may not
be appropriate because your network it will occupy 9
channels bandwidth (in 2.4G), thus you will experience
mutual interference and reduced speed.
Click Apply to save the settings.
Note:
By default, there are only 16 allowed computers for each WiFI which
are enough for home or small office. Refer to further section titled
“advanced wireless” to increase this number.
To Next Page
Loading...
