Zte H108N - Wireless Basics

ZTE H108N V.2.1 Configuration manual
Page 22 ZTE Proprietary and Confidential
2.3.1 Wireless Basics
In the Wireless page, click Wireless Basic. The page shown in the following
figure appears. In this page, you can configure the parameters of wireless LAN
clients that may connect to the device.
The following table describes the parameters in this page.
Field
Description
Enable
Wireless
Select this to turn Wi-Fi on.
Enable MultiAP
Isolation
Select this to turn MultiAP isolation on. In this way, the
computers in separate wireless networks will not be
able to see each other.
Wireless
Network Name
(SSID)
The Wireless Network Name is a unique name that
identifies a network. All devices on a network must
share the same wireless network name in order to
communicate on the network. If you decide to change
the wireless network name from the default setting,
enter your new wireless network name in this field.