Zte H108N - Default Generic Internet Setup

ZTE H108N V.2.1 Configuration manual
Page 16 ZTE Proprietary and Confidential
 VPI and VCI each: 8/32
 Service Category (QoS): UBR without PCR
 Connection Type: IPoA (also called static, RFC 2684, formerly 1483)
 Encapsulation mode: LLC
 WAN IP address: provided by your operator (management IP)
 WAN subnet mask: provided by your operator
 Default gateway: provided by your operator
 Preferred DNS server: by your operator (Movistar is 80.58.61.250)
 Alternate DNS server: by your operator (Movistar is 80.58.61.254)
 NAT disabled.
In the Setup->Local Network, find the section “DHCP settings”:
 DHCP IP Address Range = [Start] = [End] = provided by your operator
 DHCP IP mask = 255.255.255.252
 DHCP gateway IP = first static address of the public WAN
Then refer to the Advanced -> Routing -> RIP and ensure rules for 8/32 are
turned off.
2.2.5 Configuration for standalone device (generic)
Based on your default factory configuration you can emulate the “standalone”
scenario with much easier configuration. Simply use the DMZ to expose your
computer to internet.
Refer to section Advanced > DMZ: