Zte H108N - Time and Date Settings; Time Synchronization and Daylight Saving

ZTE H108N V.2.1 Configuration manual
Page 34 ZTE Proprietary and Confidential
The following table describes the parameters of this page.
Field
Description
IPv6 Interface
Address
The address through which your PCs access the
router (equivalent to 192.168.1.1). Here it’s default
fe80::1 which is standard local link gateway.
Enable DHCPv6
Server
Choose to enable or disable DHCPv6 service.
LAN address
config mode
Set the mode for obtaining IP from LAN PCs. You
may choose Stateless or Statefull. Stateless is
default, where all hosts get always the same IP of
type “fe80::MAC”. This is more convenient for port
redirection.
Start/End Interface
ID
The address pool using DHCPv6 for address
assignment under statefull mode.
DHCPv6 Lease
Time
The address lease time using DHCPv6 for address
assignment under statefull mode.
Enable RADVD
Choose to enable or disable router advertisement
service (RADVD). Necessary for routing to work.
Propagate WAN
Use the site prefix obtained at the WAN side as the
prefix to issue (from your Internet Provider). This is
the default and recommended configuration. Your
PCs will get a public IPv6.
Static
Manually add a site prefix. This will create an
internal network.
Note:
Even when your PCs get a public IPv6, they are still protected by the
“port filtering” function. Please refer to the section regarding port
opening.