ZTE H108N V.2.1 Configuration manual
Page 39 ZTE Proprietary and Confidential
Wireless Network Name (SSID): The Wireless Network Name is a unique name
that identifies a network. All devices on a network must share the same wireless
network name in order to communicate on the network. If you decide to change
the wireless network name from the default setting, enter your new wireless
network name in this field.
Note:
By default, there are only 16 allowed computers for each WiFI which
are enough for home or small office. You can change it in this screen,
under your WiFI name, attribute “max clients”.
The other settings are only for more technically advanced users who have
sufficient knowledge about wireless LAN. Do not change these settings unless
you know the effect of changes on the device.
Here are some tips for troubleshooting advanced users:
In a large environment, let’s say multi-roomed offices or hotel floors
(>300m²), where you have many devices (>7) with traffic collision at
the same time causing the performance speed is very low, you can
avoid this problem by reducing “RTS threshold” down to 500.
In a high interference environment, let’s say near microwaves, electric
motors, Bluetooth devices, wireless phones at home (DECT), etc,
where many packets are lost due to errors and performance speed is
low, you can avoid this problem by reducing “fragmentation threshold”
down to 820 normally or even 500. Lower values can also be used, but
it can start to affect the performance for the added overhead.
In reduced home environment, without multicast voice-video or network
gaming (none of these take place) you can increase the DTIM interval
to 2 or even 4. This will save battery on your mobile equipment (phone,
tablet and laptop) with a imperceptible delay at message reception.
Click Apply to save the settings.
To Next Page
Loading...
