ZTE H108N V.2.1 Configuration manual
Page 46 ZTE Proprietary and Confidential
The following table describes the parameters.
Select the check box to enable this service
Enter the name of your home network (LAN).
Default by windows is “Workgroup” and all
computers are placed inside.
Enter your NetBIOS name. The router will be listed
in the above “workgroup” with this name.
Enter your password to access the files.
Reconfirm your above password.
Select the check box to enable USB storage.
Select the check box to allow anonymous users
access. The password will NOT be required. This is
the default option.
Click Apply to save the settings.
Plug your USB memory drive firstly into the router, so that your computer can
detect it after one minute.
Note:
There are three ways to access the shared files on the USB port:
1) Open the “start menu” and select “run”. Paste the following address
and press OK: \\192.168.1.1\
2) On your keyboard, hold down the “Windows Logo Key” and press
letter “R” (Win+R). Paste the address and press OK: \\192.168.1.1\
3) Find the network icon on your desktop. On the left click view
workgroup computers, and find the “dsl_router”.
To Next Page
Loading...
