Zte H1600 - Page 16

8
SJ-20210621164956-008 | 2022-09-01(R1.3)
ZTE H1600 Maintenance Management Guide
Table 2-2 describes the indicators on the front panel of the ZTE H1600 unit.
Table 2-2 Descriptions of Indicators
LED Indicator
Status
Description
Power
Off
The power supply is not connected or is faulty.
Solid green
The device is powered on properly.
Solid red
The device is performing self-detection or the self-detec-
tion fails.
Broadband
(DSL)
Off
The DSL connection has not been established.
Solid green
DSL synchronization is normal and the link connection
is normal.
Flashing slowly green
Physical link exists, however carrier wave has not been
detected.
Flashing fast green
The device is in the handshaking process to establish
the link connection.
Broadband
(WAN)
Off
The device is not powered on or the WAN port is dis-
abled.
Solid green
The link is activated.
Internet
Off
The device is switched off.
Solid green
The WAN connection is online. The device has a WAN
IP address from IPCP, DHCP or statically configured.
LED remains green in the case of disconnection due
to idle timeout when PPP dial-on-demand is enabled.
Green LED indicates that the routing connection state is
up.
Solid red
The WAN connection is dialing up or fails to get online.
Device attempted to become IP connected and failed
(no DHCP response, no PPPoE response, PPP authen-
tication failed, no IP address from IPCP, etc).
2.4GHz
Off
2.4GHz WLAN RF switch is off.
Solid green
2.4GHz WLAN RF switch is on.
5GHz
Off
5GHz WLAN RF switch is off.
Solid green
5GHz WLAN RF switch is on.
WPS
Off
No WPS access or the WPS access of the terminal ex-
ceeds 2 minutes.