Zte H3140 - Configure the Qos

H3140 Maintenance Management Guide
Figure 4-7 New 3G Connection
Table 4-3 New 3G Connection parameters
Parameter Description
Connection Name Name the 3G connection.
PDP Type There are two PDP types:

IP

PPP
APN Set the communication standard of the access network to
be used.
For example ”3GNET”.
Dial Number Dial Number.
Different communication standards have different dial num-
bers.
MTU Define the maximum transfer unit.
Username/Password The Username/Password of new 3G connection.
Authentication Type There are three authentication types:

Auto

PAP

CHAP
Connection Mode There are two connection modes:

Always On

On Demand
Auto-disconnected without traffic Setting this parameter when Connection Mode is On De-
mand.
NAT Switch Select on/off NAT switch function.
5. Click Apply button to apply the changes.
4.3 Configure the QoS
22 SJ-20210621164956-009 | 2021-12-07(R1.0)