Zte H3140 - Configure the Mulitcast; Configure the IGMP; Configure the MLD

H3140 Maintenance Management Guide
Parameter Description
header of data packets to classify service types and distin-
guish service priorities.The value range of DSCP is 0~63
and each DSCP code value is mapped to a defined PHB (
Per Hop Behavior) code.
3. Click Apply button to apply the changes.
4.8 Configure the Mulitcast
4.8.1 Configure the IGMP
Abstract
The IGMP function in the IGMP PROXY mode is to act as agent for the IGMP packets
sent by the OLT equipment and forward them according to the information in the pack-
ets.
Steps
1. On the main page of the H3140, select Internet > Multicast > IGMP to the IGMP
page, see Figure 4-24.
Figure 4-24 IGMP Configuration Page
2. Enable the IGMP functions, see Table 4-18.
Table 4-18 Parameter Descriptions for the IGMP
Parameter Description
IGMP Proxy The system serves as a proxy server to forward IGMP packets
from the MDU/DSLAM to other devices.
3. Click Apply button to apply the changes.
4.8.2 Configure the MLD
Abstract
When the MLD proxy function is enabled on H3140, H3140 can enable the proxy down-
stream host to send MLD messages and maintain the group member relationship, and
40 SJ-20210621164956-009 | 2021-12-07(R1.0)