Zte H3140 - Configure the Local Service Control

H3140 Maintenance Management Guide
Parameter Description

If the ingress is a WAN or 3G connection, the egress
should be the LAN. The data traffic direction is down-
stream.
Egress Specify the data traffic direction. The Ingress option and
egress option cannot be the same.

If the ingress is LAN, the egress should be a WAN or 3G
connection. The data traffic direction is upstream.

If the ingress is a WAN or 3G connection, the egress
should be the LAN. The data traffic direction is down-
stream.
DSCP A DSCP is specified for the TOS byte in the IP header of each
packet to indicate the priority. Range: 0–63.
10.Click Apply button to apply the changes.
4.4.3 Configure the Local Service Control
Abstract
The procedure describes how to configure local service control, including local service
control-IPv4 and local service control-IPv6.
Steps
Configure the Service Control-IPv4
1. On the main page of the H3140, select Internet > Security > Local Service Control
to the Local Service Control page.
2. Click Service Control-IPv4 to open Service Control-IPv4 page and then click the
Create New Item, see Figure 4-15.
30 SJ-20210621164956-009 | 2021-12-07(R1.0)