Zte H3140 - SIP Account Configuration

6 Configure the VoIP
6.2 Configure the SIP Accounts
Abstract
This procedure describes how to configure basic parameters of the VoIP service, includ-
ing sip account, authorization username, password.
Steps
1. On the main page of the H3140, select VoIP > Basic. The SIP Account-1 page is
displayed, see Figure 6-2.
Figure 6-2 SIP Account-1 Page
2. Set the parameters. For a description of the parameters, refer to Table 6-1.
Table 6-1 Parameter Descriptions for the SIP Account-1
Parameter Description
Enable Specifies whether to enable the VoIP service.
SIP Account Registered name of a SIP subscriber. Normally, it is the phone number of the
subscriber.
Authorization
Username
Username for authentication by the SS system, which must be the same as
that configured in the SS system.
Password Password for VoIP service authentication by the SS system, which must be
the same as that configured in the SS system.
3. Click Apply button to apply the changes.
Note
SIP Account-2 configuration refers to SIP Account-1 configuration.
SJ-20210621164956-009 | 2021-12-07(R1.0) 67