H3140 Maintenance Management Guide
5.5 Configure the FTP Server Feature
Abstract
This procedure describes how to enable the FTP feature of the H3140 by configuring
FTP parameters, including the username and password.
Steps
1. In the left navigation tree, click Local Network > FTP. The FTP Application page is
displayed, see Figure 5-24.
Figure 5-24 FTP Page
2. Set the parameters. For a description of the parameters, refer to Table 5-18.
Table 5-18 FTP Server Parameter Descriptions
Parameter Description
Server Enable or disable the FTP server feature .
FTP Username/FTP Pass-
word
Username and password used to connect to the FTP server.Valid
only if FTP security control is enabled.
3. Click On to enable the FTP server feature, and click Apply button to apply the
changes.
5.6 Configure the UPnP
Abstract
The UPnP function is used to support zero configuration, invisible networking, and auto-
matic discovery of vendor device types. After the UPnP function is configured, a device
can dynamically join a network to obtain its IP address, report its functions, and learn
about the functions of other devices.
Steps
Enable or Disable the UPnP Function
62 SJ-20210621164956-009 | 2021-12-07(R1.0)
To Next Page
Loading...
