Zybio EXI1820 - Stop; Logout

Basic Operating Methods
６４
a submit confirmation box will pop up;
6) Check "Continue the sample test submitted before pause" to resume the test.
Attention
1) After the pause, if new samples are added, and only the
samples before the pause need to be resumed for testing.
As mentioned above, you can check "Continue the
sample tests submitted before pause" in the submit test
confirmation pop up to resume testing;
2) After the pause, a new sample is added. If both the new
sample and the sample before the pause need to start
testing. You can select [All] to submit in the submit test
confirmation dialog box. The test before the pause will be
resumed by default, and the additional new samples will
be submitted;
3) After the pause, a new sample is added. If both the new
sample and the sample before the pause need to start
testing. You can also select [Specified Sample Position] in
the submit test confirmation dialog box to submit, and
input the additional sample position to be tested, the
submit will resume the paused test by default, and add
new sample tests at the same time.
3.15.Stop
Stop all tests in testing, users can stop the current work of the analyzer for emergent
situations.
Basic operation
1) Click the button on the upper right of the software interface, the sample
adding operation will be stopped;
2) All operating of the analyzer operation parts will be stopped, the sample
shows “Unfinished”, and the sample item shows “Invalid, need to toss the
cuvettes.”
3.16.Logout
The analyzer can be switched to a new account and password by logout function,
and logged in to the operating software with them.
1) Confirm that the system is in standby state;