Zybio EXI1820 - Sample Testing and QC Procedures

Basic Operating Methods
４９
Parameters
Meaning
Operation
Mean
Average value after two calibration tests of the
calibration points
No operation
required
CV
CV calculated from calibration points
No operation
required
Expect Value
Theoretical concentration value of the calibrator
No operation
required
Basic operations
◼ Check the master calibration curve, calibration results and calibration curve:
1) Click [Reagent] - [Reagent List];
2) Click the reagent to check calibration information;
3) Click [Calibration Information], the calibration information interface will pop up;
4) In the calibration interface, “red” means master curve, “green” means master
calibration curve;
5) Select calibration result to be viewed in [Calibration Information];
6) The detailed calibration test results will be showed in the below of calibration curve.
3.11.QC test
As the result of QC can ensure the accuracy of the sample test results, it is
recommended to perform QC test every day.
3.11.1.QC request
It is allowed to apply for QC test based on controls. Before QC test, you need to set the
corresponding target value and SD value, otherwise the default value is 0.
3.11.1.1.QC settings
Click [QC] to enter the interface of the following figure: