Zybio EXI1820 - Page 91

Software System Operation
９１
Basic parameter explanation
Parameters
Meaning
Operation
IP address
IP address for communication
with the lower computer
Enter the IP address of the lower
computer directly in the box
Port
Port number for
communication with the lower
computer
Enter the port number of the lower
computer directly in the box,
default is 1800
Connect/disconne
ct
Connect or disconnect from
the lower computer
After setting up the IP address
and port number, click [Connect]
to connect to the lower computer
for communication
Auto-connection
Automatically connect to the
lower computer when the
software is started
Check or uncheck, check by
default
Information setting
Setting of the agent of
analyzer
No operation required
Initial setting
Initialization settings after
starting
Click to select
Voice setting
Software and fault alarm
volume control
You can drag the control switch
and volume
Basic operations
1) Set IP address and port number;
2) Click [Connect], the connection is successful, the control will change to the
[Disconnect] control, if the connection fails, a pop-up window will appear;
3) After successful connection, click [Disconnect], to disconnect the connection
with the lower computer;
4) Select [Auto-Connection] control button, when the software is started, it will
automatically to connect and communicate with the lower computer by fault;
5) Click [Information Setting], information about the hospital, address where the
instrument is located and agent;
6) Click [Initial Setting] to set the initialization configuration;
7) Check [Voice Setting] to set the voice of software start and instrument fault
alarm and adjust the volume.