ZyXEL Communications IES-612-51A - Page 266

Chapter 41 Commands Summary
IES-612-51A User’s Guide
266
pmm param <portlist>
[<l0time> <l2time>
<l2atpr>
<l2atprt>][<max_l2
rate> <min_l2rate>
<l0tol2_rate>]
Displays or sets the Power
Management parameter
H/H
dsbcast enable <portlist>
<vlanlist>
Enable downstream broadcast on
xDSL port
H/H
dsbcast disable <portlist>
<vlanlist>
Disable downstream broadcast on
xDSL port
H/H
dsbcast show <portlist> Show downstream broadcast on
xDSL port
M/L
reset <portlist> Reset xDSL port H/H
inp <portlist>
[<usINP>
[,<dsINP>] ]
Displays or sets the upstream (us)
and downstream (ds) Impulse
Noise Protection minimum setting
(0~3).
H/H
alarm
clear Clear current alarm M/L
cutoff Alarm cutoff M/~
xedit <alarm>|all
<cond>|<condcode>
<severity> <fac>
<target>[,<target>
] [clearable]
Edit system alarm table M/L
history clear <alarm>|all
<condition>|all
Clear history alarm M/~
history clear <severity> Clear history alarm M/~
history show [<severity>|all]
[<alarm>|all]
[<condition>|all]
[<sdate>|all]
[<edate>|all]
[for|rev] [detail]
Display history alarm L/~
show [<severity>|all]
[<alarm>|all]
[<condition>|all]
[<sdate>|all]
[<edate>|all]
[for|rev] [detail]
Display current alarm L/L
port show [<severity>|all] Display xDSL port threshold of
severity which will issue an alarm
L/L
port set <all|enet1|enet2|p
ort> <severity>
Set xDSL port threshold of
severity which will issue an alarm
M/L
Table 88 Commands (continued)
CLASS COMMAND PARAMETERS DESCRIPTION P