ZyXEL Communications IES-612-51A - Page 267

Chapter 41 Commands Summary
IES-612-51A User’s Guide
267
tablelist [<alarm>|all]
[<severity>|all]
[<fac>|all]
[<target>[,<target
>]]
[<condition>|all]
Display system alarm table L/L
switch
igmpsnoop show Displays the IGMP snooping
setting.
M/L
igmpsnoop enable <proxy|snooping> Sets IGMP snooping mode. H/H
igmpsnoop disable Turns off IGMP snooping. H/H
igmpsnoop
bandwidth default
<bandwidth> Set default bandwidth for
multicast IP channels
M/H
igmpsnoop
bandwidth delete
<index> Delete an entry of bandwidth
budget setting specified in
<index> field.
M/H
igmpsnoop
bandwidth port
disable
<portlist> Disable bandwidth budget control
for a port
M/H
igmpsnoop
bandwidth port
enable
<portlist> Enable bandwidth budget control
for a port
L/H
igmpsnoop
bandwidth port set
<portlist>
<bandwidth>
Set bandwidth threshold for a port
<bandwidth>: 1..100,000, in unit
of kbps
M/H
igmpsnoop
bandwidth port
show
<portlist> Show bandwidth control setting
for a port
L/L
igmpsnoop
bandwidth set
<index> <start-
mcast-ip> <end-
mcast-ip>
<bandwidth>
Set bandwidth budget for a range
of multicast IP channels specified
in <index> field.
<index>: 1~96
<start-mcast-ip>: <ip>, start
multicast IP address
<end-mcast-ip>: <ip>, end
multicast IP address
M/H
igmpsnoop
bandwidth show
Show bandwidth budget for a
range of multicast IP channels
L/L
igmpsnoop
igmpcount disable
<portlist> Disable IGMP count limiting to
subscriber port
H/H
igmpsnoop
igmpcount enable
<portlist> Enable IGMP count limiting to
subscriber port
H/H
igmpsnoop
igmpcount set
<portlist> <count> Set IGMP count limiting number to
subscriber port
H/H
igmpsnoop
igmpcount show
[portlist] Display IGMP count limiting
setting status on the specified slot
M/L
Table 88 Commands (continued)
CLASS COMMAND PARAMETERS DESCRIPTION P