ZyXEL Communications IES-612-51A - Page 274

Chapter 41 Commands Summary
IES-612-51A User’s Guide
274
smcast set <adsl_port> <mac>
<join|leave>
Use join/leave to add/ remove
multicast MAC addresses on
specified ADSL ports, a range of
ADSL ports or all ADSL ports.
MAC example: 01005E010203
H/H
smcast delete <mac> Removes a static multicast filter
entry by deleting the associated
MAC address.
H/H
isolation show Displays the subscriber isolation
feature’s current setting.
M/L
isolation enable Turns the subscriber isolation
feature on.
H/H
isolation disable Turns the subscriber isolation
feature off.
H/H
isolation
daisychain
Set switch mode to daisychain
mode
H/H
isolation
standalone
Set switch mode to standalone
mode
H/H
ip
show [inband|outband] Displays the Management IP
address settings.
M/L
arp show Displays the device’s IP Address
Resolution Protocol(ARP) table.
M/L
arp flush Clears the device’s IP Address
Resolution Protocol(ARP) table.
H/H
set <ip>[/netmask] Sets the Management IP address
and subnet mask.
H/H
gateway <gateway ip> Sets the IP address of the
device’s default gateway.
H/H
route show Displays the routing table. M/L
route set <dst ip>[/netmask]
<gateway ip>
[metric] <name>
Adds a routing table entry. H/H
route set default <gateway
ip> <metric>
Sets the device’s default route. H/H
route delete <dst ip>[/netmask] Removes a routing table entry. H/H
route flush Clears the routing table. H/~
ping <ip> [count] Pings a remote host. M/L
statistics
monitor Displays hardware monitor status. M/L
adsl show [portlist] Displays ADSL port connection
status.
M/L
adsl linedata <portlist> Displays the line data load per
symbol (tone).
M/L
adsl lineinfo <portlist> Displays the info of the specified
ADSL ports.
M/L
Table 88 Commands (continued)
CLASS COMMAND PARAMETERS DESCRIPTION P