ZyXEL Communications IES-612-51A - Page 273

Chapter 41 Commands Summary
IES-612-51A User’s Guide
273
dot1x disable Turn off dot1x. H/H
dot1x auth <profile|radius> Set authentication method to
profile or radius.
H/H
dot1x port enable <portlist> Turn on dot1x on port. H/H
dot1x port disable <portlist> Turn off dot1x on port. H/H
dot1x port control <portlist>
<auto|auth|unauth>
Set port authentication status. H/H
dot1x port reauth <portlist>
<on|off>
Turn on or turn off port to do
reauthentication.
H/H
dot1x port period <portlist>
<period>
Set port reauth period. H/H
dot1x radius show Display radius server settings. M/L
dot1x radius ip <ip> Set Radius server IP. H/H
dot1x radius port <port> Set Radius server port. H/H
dot1x radius
secret
<secret> Set Radius server secret. H/H
dot1x profile show Display accounts for profile mode. M/L
dot1x profile set <name> <password> Set account and password for
profile mode.
H/H
dot1x profile
delete
<name> Remove account for profile mode. H/H
enet show Displays the Ethernet port
settings.
M/L
enet speed <portlist>
<10copper|100coppe
r|auto>
Sets the Ethernet port(s)
connection speed.
H/H
enet name <portlist> <name> Sets the Ethernet port(s) name. H/H
enet enable <portlist> Turns on the specified Ethernet
port(s).
H/H
enet disable <portlist> Turns off the specified Ethernet
port(s).
H/H
enet reset <portlist> Reset the ENET interface H/H
enet length show Manually set the ENET cable
length, this is used for very rare
cases when connect to some
ENET PHY, in most cases, should
set to auto(system default)
M/~
enet length set <portlist>
auto|<length>
Display the ENET cable length
setting, <length>: 0-15, in units of
10 m
H/~
smcast show Display all MAC addresses joined
to ADSL ports.
M/L
Table 88 Commands (continued)
CLASS COMMAND PARAMETERS DESCRIPTION P