Chapter 6 WAN
LTE3301 Series User’s Guide
59
(These fields appear when the IPv6 Connection is set to DHCPv6.)
DNS Setting Select Obtain DNS Server address Automatically to have the LTE3301 get the
IPv6 DNS server addresses from the ISP automatically.
Select Use the following DNS address to have the LTE3301 use the IPv6 DNS
server addresses you configure manually.
Primary DNS Address
Enter the first IPv6 DNS server address assigned by the ISP.
Secondary DNS
Address
Enter the second IPv6 DNS server address assigned by the ISP.
(These fields appear when the IPv6 Connection is set to PPPoE.)
Address Mode Select Dynamic IP if you have a dynamic IP address.
Select Static IP if the ISP assigned a fixed IP address.
IP Address Enter the static IP address provided by your ISP.
Username Enter a user name (of up to 31 printable characters) for login using PPPoE
connection.
Password Enter the password associated with the user name above.
Service Name Enter the name of your PPPoE service here.
Reconnect Mode Select Auto Reconnect (always-on) if you do not want the connection to time out.
Select Connection-on-Demand if you want to connect for a certain amount of time
before the router automatically disconnects from the PPPoE server. If you select this
you will need to enter the number of minutes in the Maximum Idle Time field.
Select Manually if want to make the connection manually.
Maximum Idle Time Specify the time in minutes that elapses before the LTE3301 automatically
disconnects from the PPPoE server.
(These fields appear when the IPv6 Connection is set to 6RD.)
Remote IPv4 Address Enter the IPv4 address of the relay server,
IPv4 Mask Length Enter the IPv4 subnet mask number (1 to 32).
Remote Prefix Enter an IPv6 prefix for tunneling IPv6 traffic to the ISP’s Border Relay router and
connecting to the native IPv6 Internet.
Prefix Length Enter the address prefix length to specify how many most significant bits in an IPv6
address compose the network address.
Primary DNS Address
Enter the first IPv6 DNS server address assigned by the ISP.
Secondary DNS
Address
Enter the second IPv6 DNS server address assigned by the ISP.
LAN IPv6 Address Enter the IPv6 address for the LTE3301 LAN interface in this field.
LAN IPv6 Link-Local
Address
This shows the IPv6 Link-local address in the LAN side. This is used by LTE3301 when
communicating with neighboring devices on the same link. It allows IPv6-capable
devices to communicate with each other in the LAN side.i
Autoconfiguration Click Enable if you want the devices on your local area network to obtain network
address that are not managed by a DHCPv6 server. Otherwise, select Disable.
Autoconfiguration Type Select Stateless if you want the LTE3301 interface to automatically generate a link-
local address via stateless autoconfiguration.
Select Stateful (DHCPv6) when the devices connected to your LAN needs to have
their TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
IPv6 Address
Range(Start)
If you select Stateful (DHCPv6), specify the range of IPv6 addresses from which
the DHCPv6 server assigns to the clients. Enter the smallest value of the last block of
the IPv6 addresses which are to be allocated.
Table 16 Network > WAN > IPv6 (continued)
LABEL DESCRIPTION
To Next Page
Loading...
