Chapter 6 Router
LTE4506 User’s Guide
56
6.2 LAN IP Screen
Use this screen to view or configure the management IP address for your LTE4506. To access this screen,
click Router > LAN IP.
Note: If you change the LTE4506’s IP address, you need to use the new IP address to access
the LTE4506’s Web Configurator.
Figure 31 Router > LAN IP
The following table describes the labels in this screen.
6.3 DHCP Server Screen
The LTE4506 has built-in DHCP server capability that assigns IP addresses to systems that support DHCP
client capability. Use this screen to enable the DHCP server. To access this screen, click Router > DHCP
Server.
Table 22 Router > LAN IP
LABEL DESCRIPTION
Host Name This shows the default host name.
Enter the new host name for the LTE4506 if you want to change it.
IP Address This shows the default LAN IP address.
Enter the new IP address for the LTE4506’s LAN interface if you want to change it.
Subnet Mask This shows the default subnet mask.
Enter the subnet mask of this interface in dot decimal notation. The subnet mask indicates
what part of the IP address is the same for all computers in the network.
Apply Click Apply to save your changes back to the LTE4506.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
