ZyXEL Communications LTE4506-M606 - 6.7 IPv6;Port Filter Screen

Chapter 6 Router
LTE4506 User’s Guide
60
6.7 IPv6/Port Filter Screen
The LTE4506 firewall is a packet filtering firewall and restricts access based on the source/destination
computer network address of a packet and the type of application. Use this screen to configure IP
filtering rules. To access this screen, click Router > Firewall > IPv6/Port Filter.
Figure 36 Router > Firewall > IPv6/Port Filter
The following table describes the labels in this screen.
Port This field displays a single port number of the destination or a port range.
Enter the port number/range of the destination that define the traffic type, for example TCP port
80 defines web traffic.
Comment Enter descriptions of the rule in this field.
Action Click Edit to go to the screen where you can edit the filtering rule.
Click Delete to remove the filtering rule.
Apply Click this button to save your changes back to the LTE4506.
Reset Click Reset to reload the previous configuration for this screen.
Table 26 Router > Firewall > IPv4/Port Filter
LABEL DESCRIPTION
Table 27 Router > Firewall > IPv6/Port Filter
LABEL DESCRIPTION
IPv6/Port Filter
Enable IPv6/Port
Filter
Select the check box to enable the rule.
IPv6/Port
Filtering Policy
Select Whitelist to allow packets that match the filtering rules defined on this screen to pass
through. Select Blacklist to block packets that match the filtering rules defined on this screen.
IPv6/Port Filter List
Add New Click Add New to create a new rule.
This field displays the rule index number.
Source IP This field displays the source IPv6 addresses to which this rule applies.