Chapter 6 Router
LTE4506 User’s Guide
61
6.8 URL Filter Screen
Use this screen to block the users on your network from accessing certain web sites. To access this
screen, click Router > Firewall > URL Filter.
Figure 37 Router > Firewall > URL Filter
The following table describes the labels in this screen.
Port This field displays a single port number of the source or a port range.
Enter the port number/range of the source that define the traffic type, for example TCP port 80
defines web traffic.
Protocol This field displays the protocol (TCP, UDP, TCP+UDP or any) used to transport the packets for
which you want to apply the rule.
Dest. IP This field displays the destination IPv6 addresses to which this rule applies.
Port This field displays a single port number of the destination or a port range.
Enter the port number or range of the destination that define the traffic type, for example TCP
port 80 defines web traffic.
Comment Enter descriptions of the rule in this field.
Action Click Edit to go to the screen where you can edit the filtering rule.
Click Delete to remove the filtering rule.
Apply Click this button to save your changes back to the LTE4506.
Reset Click Reset to reload the previous configuration for this screen.
Table 27 Router > Firewall > IPv6/Port Filter
LABEL DESCRIPTION
Table 28 Router > Firewall > URL Filter
LABEL DESCRIPTION
URL filter
Enable URL Filter Select the check box to enable the rule.
To Next Page
Loading...
