Chapter 13 Remote Management
NBG-418N v2 User’s Guide
117
The following table describes the labels in this screen.
Table 49 Management > Remote MGMT > WWW
LABEL DESCRIPTION
Enable WWW Click the Enable WWW check box to configure your NBG-418N v2 via HTTP using
a web browser.
Server Port You may change the Server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Secured Client WAN IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the
NBG-418N v2 using this service.
Select All to allow any computer to access the NBG-418N v2 using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the NBG-418N v2 using this service.
Note: This only applies on WAN IP.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
