Chapter 6 Wireless LAN
NBG-418N v2 User’s Guide
74
6.11 AP Select Screen
Use this screen to choose an access point that you want the NBG-418N v2 in universal repeater
mode) to connect to. You should know the security settings of the target AP.
To open this screen, click Network > Wireless LAN > AP Select tab.
Figure 52 Network > Wireless LAN > AP Select
The following table describes the labels in this screen.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to reload the previous configuration for this screen.
Table 26 Network > Wireless LAN > MBSSID
LABEL DESCRIPTION
Table 27 Network > Wireless LAN > AP Select
LABEL DESCRIPTION
AP Select
First Click First button to go to the first page of the AP select table.
Previous Click Previous button to go to the Previous page in the AP select table.
Next Click Next button to go to the next page in the AP select table.
Last Click Last button to go to the last page of the AP select table.
Select Use the radio button to select the wireless device to which you want to connect.
SSID This displays the Service Set IDentity of the wireless device. The SSID is a unique name
that identifies a wireless network. All devices in a wireless network must use the same
SSID.
MAC This displays the MAC address of the wireless device.
Channel This displays the channel number used by this wireless device.
To Next Page
Loading...
