NBG-418N v2 User’s Guide
139
CHAPTER 19
Sys OP Mode
19.1 Overview
The Sys OP Mode (System Operation Mode) function lets you configure select the device operation
mode: Router, Access Point, or Universal Repeater.
See Chapter 4 on page 29 for more information on which mode to choose.
19.2 General Screen
Use this screen to select how you connect to the Internet.
Figure 106 Maintenance > Sys OP Mode > General
The following table describes the labels in the General screen.
If you select Router mode, the following pop-up message window appears.
Table 58 Maintenance > Sys Op Mode > General
LABEL DESCRIPTION
System Operation Mode
Router Use Router mode if you want to use routing functions such as LAN DHCP, NAT, firewall
and so on, on the NBG-418N v2 (N). The NBG-418N v2 has separate LAN and WAN
network IP addresses.
Access Point Use Access Point mode if you already have a Router (R) in your network and you want
to bridge all wired and wireless network connections.
Universal Repeater Use Universal Repeater mode if there is an existing wireless router or access point in
your network and you want the NBG-418N v2 to wirelessly relay communications from
its wireless clients to it.
Apply Click Apply to save your settings.
Reset Click Reset to return to the previous screen settings.
To Next Page
Loading...
