Chapter 19 Sys OP Mode
NBG-418N v2 User’s Guide
140
Figure 107 Maintenance > Sys Op Mode > General: Router
• In this mode there are both LAN and WAN ports. The LAN Ethernet and WAN Ethernet ports have
different IP addresses.
• The DHCP server on your device is enabled and allocates IP addresses to other devices on your
local network.
• The LAN IP address of the NBG-418N v2 is set to 192.168.1.1.
• You can configure the IP address settings on your WAN port. Contact your ISP or system
administrator for more information on appropriate settings.
If you select a non-router mode (Access Point, or Universal Repeater) the following pop-up
message window appears.
Figure 108 Maintenance > Sys Op Mode > General: Non-Router
• In non-router mode, all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port labeled WAN. There is
no WAN port.
• The DHCP server on your device is disabled. In this mode there must be a device with a DHCP
server on your network such as a router which can allocate IP addresses or else you need to
manually assign IP addresses to devices on your network.
• The LAN IP address of the NBG-418N v2 is set to 192.168.1.2.
To Next Page
Loading...
