ZyXEL Communications NBG-418N v2 - Status Screen (Universal Repeater Mode)

Chapter 4 Modes
NBG-418N v2 User’s Guide
40
2 The default LAN IP address of the NBG-418N v2 is 192.168.1.1 in router mode (192.168.1.2 by
default in non-router mode). In router mode, the NBG-418N v2 can assign your computer an IP
address, so you must set your computer to get an IP address automatically (computer factory
default) or give it a fixed IP address in the range between 192.168.1.3 and 192.168.1.254.
3 After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and
type the IP address of the NBG-418N v2 as the web address in your web browser.
4 Log into the Web Configurator. See the Chapter 2 on page 17 for instructions on how to do this.
5 Go to Maintenance > Sys OP Mode > General and select Universal Repeater.
Figure 27 Maintenance > Sys OP Mode > General
6 A pop-up window appears providing information on this mode. Click OK in the pop-up message
window. Click Apply. Your NBG-418N v2 is now in Universal Repeater mode.
Note: Wait while the NBG-418N v2 restarts, then log in to the Web Configurator again.
4.4.1 Status Screen (Universal Repeater Mode)
Click on Status. The screen below shows the status screen in Universal Repeater Mode.