Chapter 3 Connection Wizard
NBG-418N v2 User’s Guide
23
By implementing PPPoE directly on the NBG-418N v2 (rather than individual computers), the
computers on the LAN do not need PPPoE software installed, since the NBG-418N v2 does that part
of the task. Furthermore, with NAT, all of the LAN's computers will have Internet access.
Figure 9 Wizard Step 2: PPPoE Connection
The following table describes the labels in this screen.
3.2.2 Dynamic IP Connection
Use the dynamic IP connection when your network administrator or ISP assigns your IP address
dynamically.
Table 4 Wizard Step 2: PPPoE Connection
LABEL DESCRIPTION
PPPoE
User Name Type the user name given to you by your ISP.
Password Type the password associated with the user name above.
Confirm Password Type the password again for confirmation.
Account Validate Click the Account Validate button to establish the Internet connection via PPPoE
encapsulation.
Back Click Back to return to the previous screen.
Next Click Next to continue.
Exit Click Exit to close the wizard screen without saving.
To Next Page
Loading...
