Chapter 4 Modes
NBG-418N v2 User’s Guide
39
Figure 26 Menu: AP Mode
The following table describes the sub-menus.
4.4 Setting your NBG-418N v2 to Universal Repeater Mode
1 Connect your computer to the LAN port of the NBG-418N v2.
Table 13 Menu: AP Mode
LINK TAB FUNCTION
Network
Wireless LAN General Use this screen to configure wireless LAN.
MAC Filter Use the MAC filter screen to configure the NBG-418N v2 to block access
to devices or block the devices from accessing the NBG-418N v2.
Advanced This screen allows you to configure advanced wireless settings.
WPS Use this screen to configure WPS.
WPS Station Use this screen to add a wireless station using WPS.
Scheduling Use this screen to schedule the times the Wireless LAN is enabled.
MBSSID Use this screen to set the SSID for wireless AP.
LAN IP Use this screen to configure LAN IP address and subnet mask.
Maintenance
System General Use this screen to view and change administrative settings such as
system and domain names, password and inactivity timer.
Time Setting Use this screen to change your NBG-418N v2’s time and date.
Logs View Log Use this screen to view the logs for the categories that you selected.
Tools Firmware Use this screen to upload firmware to your NBG-418N v2.
Configuration Use this screen to backup and restore the configuration or reset the
factory defaults to your NBG-418N v2.
Restart This screen allows you to reboot the NBG-418N v2 without turning the
power off.
Sys OP Mode General This screen allows you to select the device operation mode: Router,
Access Point, or Universal Repeater.
Language Language This screen allows you to select the language you prefer.
To Next Page
Loading...
