ZyXEL Communications NBG-418N v2 - 5.4 Enable and Configure Wireless Security without WPS on your NBG-418 N v2

Chapter 5 Tutorials
NBG-418N v2 User’s Guide
48
5.4 Enable and Configure Wireless Security without WPS
on your NBG-418N v2
This example shows you how to configure wireless security settings with the following parameters
on your NBG-418N v2.
Follow the steps below to configure the wireless settings on your NBG-418N v2.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 2.2 on page 17).
1 Open the Wireless LAN > General screen in the NBG-418N v2’s Web Configurator.
2 Make sure the Enable Wireless LAN check box is selected.
3 Enter SSID_Example3 as the SSID and select a channel.
4 Set security mode to WPA-PSK(AES) and enter ThisismyWPA-PSKpre-sharedkey in the Pre-
Shared Key field. Click Apply.
Figure 33 Tutorial: Network > Wireless LAN > General
5 Open the Status screen. Verify your wireless and wireless security settings under Device
Information and check if the WLAN connection is up under Interface Status.
SSID SSID_Example3
Channel 6
Security WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)