ZyXEL Communications NBG-418N v2 - 7.5 IPv6 Screen

Chapter 7 WAN
NBG-418N v2 User’s Guide
82
The following table describes the labels in this screen.
7.5 IPv6 Screen
Use this screen to configure your IPv6 settings. Click Network > WAN > IPv6.
Figure 57 Network > WAN > IPv6 (Link-local Only)
The following table describes the labels in this screen.
Table 30 Network > WAN > Advanced
LABEL DESCRIPTION
Multicast Setup
Multicast Proxy Click the Multicast Proxy radio button to enable this function on the NBG-418N v2.
This allows an IPv6 router to discover the presence of MLD hosts who wish to receive
multicast packets and the IP address of multicast groups the hosts want to join on its
network.
Multicast Snooping Click the Multicast Snooping radio button to activate it. This allows the NBG-418N v2
to check MLD packets passing through it and learn the multicast group membership. It
helps reduce multicast traffic.
Auto IP Setup
Enable Auto-IP-
Change mode
Click Enable Auto-IP-Change mode button to have the NBG-418N v2 change its LAN
IP address to 10.0.0.1 or 192.168.1.1 accordingly when the NBG-418N v2 gets a
dynamic WAN IP address in the same subnet as the LAN IP address 192.168.1.1 or
10.0.0.1.
The NAT, DHCP server and firewall functions on the NBG-418N v2 are still available in
this mode.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
Table 31 Network > WAN > IPv6 (Link-local Only)
LABEL DESCRIPTION
IPv6 Connection
Type
Select Link-local only to allow NBG-418N v2 to communicate with neighboring devices
on the same link. This mode enables IPv6-capable devices to communicate with each
other in the LAN side.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.