ZyXEL Communications NBG-418N v2 - Page 41

Chapter 4 Modes
NBG-418N v2 User’s Guide
41
Figure 28 Status Screen (Universal Repeater Mode)
The following table describes the labels shown in the Status screen.
Table 14 Status Screen (Universal Repeater Mode)
LABEL DESCRIPTION
Device Information
System Name This is the System Name you enter in the Maintenance > System >
General screen. It is for identification purposes.
Firmware Version This is the current firmware version of the NBG-418N v2.
LAN Information
- MAC Address This shows the LAN Ethernet adapter MAC Address of your device.
- IP Address This shows the LAN port’s IP address.
- IP Subnet Mask This shows the LAN port’s subnet mask.
- DHCP Server This shows the LAN port’s DHCP server.
WLAN AP Information
- MAC Address This shows the wireless adapter MAC Address of your device.
- Status This shows the current status of the Wireless LAN - On, Off, or Off by
scheduler.
- Name (SSID) This shows a descriptive SSID name used to identify the NBG-418N v2 in the
wireless LAN.
- Channel This shows the channel number which you select manually or the NBG-418N
v2 automatically scans and selects.
- Operating Channel This shows the channel number which the NBG-418N v2 is currently using over
the wireless LAN.
- Security Mode This shows the level of wireless security the NBG-418N v2 is using.
- 802.11 Mode This shows the IEEE 802.11 standard that the NBG-418N v2 supports. Wireless
clients must support the same standard in order to be able to connect to the
NBG-418N v2