Chapter 7 WAN
NBG-418N v2 User’s Guide
90
Figure 63 Network > WAN > IPv6 (6rd)
IPv6 DNS Settings
Primary/Secondary
DNS Address
Enter the Primary and Secondary DNS address for the IPv6 server in the appropriate
box fields.
Lan IPv6 Address Settings
LAN IPv6 Address Enter the IPv6 IP address for the LAN port in this field.
LAN IPv6 Link-Local
Address
Enter the IPv6 Link-local address in the LAN side. This is used by routers when
communicating with neighboring devices on the same link. It allows IPv6-capable
devices to communicate with each other in the LAN side.i
Address Autoconfiguration Settings
Enable
Autoconfiguration
Click Enable Autoconfiguration if you want the devices on your local area network to
obtain network address that are not managed by a DHCPv6 server.
Autoconfiguration
Type
Select SLAAC + Stateless DHCPv6 if you want the interface to automatically generate
a link-local address via stateless autoconfiguration.
Select Stateful(DHCPv6) when the devices connected to your LAN needs to have their
TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router
Advertisement
Lifetime
Type in the Router Advertisement Lifetime which is amount of time in minutes that a
device may have an IPv6 address before it is required to renew the lease.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
Table 36 Network > WAN > IPv6 (continued)(6 to 4)
LABEL DESCRIPTION
To Next Page
Loading...
