Chapter 10 Static Route
P-870HW-51a v2 User’s Guide
115
Figure 61 Static Route: Add
The following table describes the labels in this screen.
Table 36 Static Route: Add
LABEL DESCRIPTION
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Use Interface Select a predefined interface through which the traffic is sent. If you select a WAN
interface using PPPoE you must specify the gateway IP address.
Use Gateway IP
Address
Select this option and enter the IP address of the next-hop gateway. The gateway is
a router or switch on the same segment as your ZyXEL Device's interface(s). The
gateway helps forward packets to their destinations.
Back Click Back to return to the previous screen without saving.
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
