ZyXEL Communications P-870HW-51A V2 - Table 41 Qos Class Configuration

Chapter 11 Quality of Service (QoS)
P-870HW-51a v2 User’s Guide
123
The following table describes the labels in this screen.
Table 41 QoS Class Configuration
LABEL DESCRIPTION
Active Select to enable or disable this classifier.
Name Enter a descriptive name of up to 20 printable English keyboard characters,
including spaces.
Interface Select from which Ethernet port traffic of this class should come.
Select Local for any traffic from the LAN.
Order Select an existing number for where you want to put this classifier to move the
classifier to the number you selected after clicking Apply.
Select Last to put this rule in the back of the classifier list.
Ether Type Select a predefined application to configure a class for the matched traffic.
If you select IP, you also need to configure source or destination MAC address,
IP address, DHCP options, DSCP value or the protocol type.
If you select 8021Q, you can only configure a 802.1p priority level.
Tag Configuration
Assign
Classification
Queue
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Mark Differentiated
Services Code
Point (DSCP)
Select a DSCP value with which the ZyXEL Device replaces the DSCP field in
the packets.
Select Auto Marking and the ZyXEL Device will change the DSCP value to an
IP ToS value when there is a 802.1p priority field in the matched packets.
Select default to set the DSCP value in the matched packets to 0.
Mark 802.1p priority Select a priority level with which the ZyXEL Device replaces the IEEE 802.1
priority field in the packets.
Tag VLAN ID Select a VLAN ID number (between 0 and 4095) with which the ZyXEL Device
replaces the VLAN ID of the frames.
Set Rate
Control(kbps)
Enter the transmission rate (in Kbps) for traffic that matches this QoS class
Filter Configuration
Use the following fields to configure the criteria for traffic classification.
Source
Address Enter the source IP address in dotted decimal notation.
Subnet Mask Enter the source subnet mask.
Port If you select a protocol type, enter the port number(s) of the source. 0 means
any source port number.
MAC Address Enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits a packet’s
MAC address should match.
Enter “f” for each bit of the specified source MAC address that the traffic’s MAC
address should match. Enter “0“ for the bit(s) of the matched traffic’s MAC
address, which can be of any hexadecimal character(s). For example, if you set
the MAC address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet
with a MAC address of 00:13:49:12:34:56 matches this criteria.
Destination
Address Enter the destination IP address in dotted decimal notation.
Subnet Mask Enter the destination subnet mask.