ZyXEL Communications P-870HW-51A V2 - Figure 63 Qos Queue Setup; Table 38 Qos Queue Setup; The Queue Setup Screen

Chapter 11 Quality of Service (QoS)
P-870HW-51a v2 User’s Guide
119
11.4 The Queue Setup Screen
Click QoS > Queue Setup to open the screen as shown next.
Use this screen to configure QoS queue assignment.
Figure 63 QoS Queue Setup
The following table describes the labels in this screen.
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.
Table 37 QoS
LABEL DESCRIPTION
Table 38 QoS Queue Setup
LABEL DESCRIPTION
Add Click this button to create a new entry.
No This is the index number of this entry.
Active Select the check box to enable the queue.
Name This shows the descriptive name of this entry.
Interface This shows the name of the ZyXEL Device’s interface through which traffic in this
queue passes.
Precedence This shows the priority queue of this entry.
Modify Click the edit icon to go to the screen where you can edit the queue.
Click the remove icon to delete an existing queue. Note that subsequent rules move
up by one when you take this action.
Apply Click Apply to save your changes back to the ZyXEL Device.