ZyXEL Communications P-870HW-51A V2 - Figure 46 Wireless LAN > MAC Filter; Table 24 Network > Wireless LAN > WPS Station; The MAC Filter Screen

Chapter 7 Wireless LAN
P-870HW-51a v2 User’s Guide
86
The following table describes the labels in this screen.
7.7 The MAC Filter Screen
This screen allows you to configure the ZyXEL Device to give exclusive access to specific
devices (Allow) or exclude specific devices from accessing the ZyXEL Device (Deny). Every
Ethernet device has a unique MAC (Media Access Control) address. The MAC address is
assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02. You need to know the MAC addresses of the devices to configure this
screen.
Use this screen to change your ZyXEL Device’s MAC filter settings.Click Network >
Wireless LAN > MAC Filter. The following screen displays.
Figure 46 Wireless LAN > MAC Filter
Table 24 Network > Wireless LAN > WPS Station
LABEL DESCRIPTION
Push Button Click this button to add another WPS-enabled wireless device (within wireless
range of the ZyXEL Device) to your wireless network. This button may either be a
physical button on the outside of device, or a menu button similar to the Push
Button on this screen.
Note: You must press the other wireless device’s WPS button within
two minutes of pressing this button.
Or input station's
PIN number
Enter the PIN of the device that you are setting up a WPS connection with and click
Start to authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device’s
settings.
Note: You must also activate WPS on that device within two minutes
to have it present its PIN to the ZyXEL Device.