Chapter 11 Quality of Service (QoS)
P-870HW-51a v2 User’s Guide
121
Figure 65 QoS Class Setup
The following table describes the labels in this screen.
Table 40 QoS Class Setup
LABEL DESCRIPTION
Add Click this button to create a new classifier.
Class Name This is the name of the classifier.
Order This field displays the index number of the classifier.
CLASSIFICATION CRITERIA
This section shows criteria specified in this classifier.
Class Intf This shows the interface through which traffic that matches this classifier is
forwarded out.
Ether Type This is the service type.
SrcMAC /Mask This shows the source MAC address and the mask of traffic of this class.
DstMAC /Mask This shows the destination MAC address and the mask of traffic of this class.
SrcIP/Mask This shows the source IP address, the source subnet mask and DHCP option 60
or DHCP option 77.
DstIP/Mask This shows the destination IP address and the destination subnet mask.
Proto This shows the protocol type.
Src Port This shows the source port number.
Dst Port This shows the destination port number.
DSCP Check This is the DSCP value of traffic of this class.
802.1P Check This shows the 802.1P priority level.
CLASSIFICATION RESULTS
Queue Key This is the index number of a queue you configured in the Queue Setup screen.
DSCP Mark This is the DSCP number added to traffic of this classifier.
802.1P Mark This is the IEEE 802.1p priority level assigned to traffic of this classifier.
VlanID Tag This is the VLAN ID number assigned to traffic of this classifier.
Rate Control
Active Select the check box to enable this classifier.
To Next Page
Loading...
