ZyXEL Communications P-870HW-51A V2 - Figure 47 Wireless LAN > Advanced Setup; Table 25 Wireless LAN > MAC Filter; The Advanced Setup Screen

Chapter 7 Wireless LAN
P-870HW-51a v2 User’s Guide
87
The following table describes the labels in this screen.
7.8 The Advanced Setup Screen
To configure advanced wireless settings, click Network > Wireless LAN > Advanced Setup.
The screen appears as shown.
Figure 47 Wireless LAN > Advanced Setup
Table 25 Wireless LAN > MAC Filter
LABEL DESCRIPTION
Active MAC
Filter
Select the check box to enable MAC address filtering.
MAC Restrict
Mode
Define the filter action for the list of MAC addresses in the table below.
Select Allow to permit access to the ZyXEL Device, MAC addresses not listed will be
denied access to the ZyXEL Device.
Select Deny to block access to the ZyXEL Device, MAC addresses not listed will be
allowed to access the ZyXEL Device
MAC
Address
Enter the MAC addresses of the wireless devices that are allowed or denied access to
the ZyXEL Device in these address fields. Enter the MAC addresses in a valid MAC
address format, that is, six hexadecimal character pairs, for example,
12:34:56:78:9a:bc.
Add Entries Click this to save and insert the entry to the table below.
Set
This is the index number of the MAC address.
MAC
Address
This is the MAC addresses of the wireless devices that are allowed or denied access to
the ZyXEL Device.
Remove Select the entry(ies) that you want to delete in the Remove column, then click the
Remove button.
Apply Click this to save your changes back to the ZyXEL Device.
Remove Click this to delete the selected entry(ies).