ZyXEL Communications P-870HW-51A V2 - Main Window; Status Bar

Chapter 3 Introducing the Web Configurator
P-870HW-51a v2 User’s Guide
42
3.2.3 Main Window
The main window displays information and configuration fields. It is discussed in the rest of
this document.
Right after you log in, the Status screen is displayed. See Chapter 4 on page 43 for more
information about the Status screen.
3.2.4 Status Bar
Check the status bar when you click Apply or OK to verify that the configuration has been
updated.
Remote MGMT TR069 Use this screen to configure the ZyXEL Device to be managed by an ACS
(Auto Configuration Server).
UPnP General Use this screen to turn UPnP on or off.
Maintenance
System General Use this screen to configure your device’s name, domain name,
management inactivity timeout and password.
Time Setting Use this screen to change your ZyXEL Device’s time and date.
Logs View Log Use this screen to view the logs for the level that you selected.
Log Settings Use this screen to change your ZyXEL Device’s log settings.
Tools Firmware Use this screen to upload firmware to your device.
Configuration Use this screen to backup and restore your device’s configuration (settings)
or reset the factory default settings.
Restart This screen allows you to reboot the ZyXEL Device without turning the
power off.
Diagnostic 802.1ag Use this screen to configure CFM (Connectivity Fault Management) and
perform connectivity tests and view test reports.
Table 3 Navigation Panel Summary
LINK TAB FUNCTION