ZyXEL Communications P-870HW-51A V2 - Configuring more Connections Advanced Setup; Figure 31 WAN > more Connections: Edit: Advanced Setup; Table 14 WAN > more Connections: Edit: Advanced Setup

Chapter 5 WAN Setup
P-870HW-51a v2 User’s Guide
61
5.5.2 Configuring More Connections Advanced Setup
To edit your ZyXEL Device's advanced WAN settings, click the Advanced Setup button in
the More Connections Edit screen. The screen appears as shown.
Figure 31 WAN > More Connections: Edit: Advanced Setup
The following table describes the labels in this screen.
Apply Click this to save the changes.
Reset Click this to begin configuring this screen afresh.
Advanced Setup Click this button to display the More Connections Advanced Setup screen and
edit more details of your WAN setup.
Table 13 WAN > More Connections: Edit (continued)
LABEL DESCRIPTION
Table 14 WAN > More Connections: Edit: Advanced Setup
LABEL DESCRIPTION
RIP & Multicast
Setup
This section is not available when you configure the ZyXEL Device to be in bridge
mode.
RIP Version RIP (Routing Information Protocol) allows a router to exchange routing information
with other routers. The version field controls the format and the broadcasting
method of the RIP packets that the ZyXEL Device sends (it recognizes both
formats when receiving). RIP-1 is universally supported; but RIP-2 carries more
information. RIP-1 is probably adequate for most networks, unless you have an
unusual network topology
This field is available only when you select ENET ENCAP.
Select the RIP version from RIPv1, RIPv2 and RIPv1v2.
RIP
Operation
This field is available only when you select ENET ENCAP.
Select Active to enable RIP. Otherwise, select Disable.