ZyXEL Communications P-870HW-51A V2 - Figure 27 WAN > Internet Connection (Pppoe); Table 10 WAN > Internet Connection

Chapter 5 WAN Setup
P-870HW-51a v2 User’s Guide
55
Figure 27 WAN > Internet Connection (PPPoE)
The following table describes the labels in this screen.
Table 10 WAN > Internet Connection
LABEL DESCRIPTION
General
Name Specify a name for this connection. You can use up to 32 letters, numerals and
any printable character found on a typical English language keyboard.
Mode The ZyXEL Device is in routing mode by default. This allows multiple computers
to share an Internet account. Select the method of encapsulation (ENET
ENCAP or PPPoE) used by your ISP from the drop-down list box.
Otherwise, select Bridge when your ISP provides you more than one IP address
and you want the connected computers to get individual IP address from ISP’s
DHCP server directly. If you select Bridge, you cannot use IP filter, DHCP
server and NAT on the ZyXEL Device.
User Name (PPPoE encapsulation only) Enter the user name exactly as your ISP assigned.
If assigned a name in the form user@domain where domain identifies a service
name, then enter both components exactly as given.
Password (PPPoE encapsulation only) Enter the password associated with the user name
above.