ZyXEL Communications P-870HW-51A V2 - Adding a Qos Queue; Figure 64 Qos Queue Setup: Add; Table 39 Qos Queue Setup: Add; The Class Setup Screen

Chapter 11 Quality of Service (QoS)
P-870HW-51a v2 User’s Guide
120
11.4.1 Adding a QoS Queue
Click the Add button or the edit icon in the Queue Setup screen to configure a queue.
Figure 64 QoS Queue Setup: Add
The following table describes the labels in this screen.
11.5 The Class Setup Screen
Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into data flows
according to specific criteria such as the source address, destination address, source port
number, destination port number or incoming interface. For example, you can configure a
classifier to select traffic from the same protocol port (such as Telnet) to form a flow.
You can give different priorities to traffic that the ZyXEL Device forwards out through the
WAN interface. Give high priority to voice and video to make them run more smoothly.
Similarly, give low priority to many large file downloads so that they do not reduce the quality
of other applications.
Click QoS > Class Setup to open the following screen.
Table 39 QoS Queue Setup: Add
LABEL DESCRIPTION
Active Select to enable or disable this rule.
Queue Name Enter the descriptive name of this rule.
Queue
Interface
Select the interface to which this rule is applied.
Queue
Precedence
Select the priority queue of this rule.
The smaller the number, the higher the priority level.
Back Click Back to return to the previous screen without saving.
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.