Chapter 16 Logs
P-870HW-51a v2 User’s Guide
148
The following table describes the fields in this screen.
16.3 The Log Settings Screen
Use the Log Settings screen to configure to where the ZyXEL Device is to send logs and
which logs and/or immediate alerts the ZyXEL Device is to record and display.
To change your ZyXEL Device’s log settings, click Maintenance > Logs > Log Settings. The
screen appears as shown.
Figure 87 Maintenance > Logs > Log Settings
The following table describes the fields in this screen.
Table 48 Maintenance > Logs > View Log
LABEL DESCRIPTION
Display Select a category of logs to view. The ZyXEL Device displays the logs with the
severity level equal to or higher than what you selected.
Refresh Click this button to renew the log screen.
# This field is a sequential value and is not associated with a specific entry.
Date/Time This field displays the time the log was recorded.
Facility This field displays the log facility in the log server or the local memory.
Severity This field displays the severity type of the log.
Message This field states the reason for the log.
Table 49 Maintenance > Logs > Log Settings
LABEL DESCRIPTION
Active Select to enable or disable system logging.
Syslog Server
IP Address
Enter the server name or the IP address of the log server.
Log Facility Select the severity level of the logs that you want the ZyXEL Device to record and
send to the log serve.
The ZyXEL Device records the logs with the severity level equal to or higher than
what you selected.
Apply Click Apply to save your customized settings and exit this screen.
Cancel Click Cancel to return to the previously saved settings.
To Next Page
Loading...
