Chapter 7 Wireless
VMG3312-T20A User’s Guide
107
7.6 The WMM Screen
Use this screen to enable Wi-Fi MultiMedia (WMM) and WMM Power Save in wireless networks for
multimedia applications.
Click Network Setting > Wireless > WMM. The following screen displays.
Figure 43 Network Setting > Wireless > WMM
The following table describes the labels in this screen.
Release
Configuration
The default WPS status is configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the VMG.
Generate
New PIN
Number
If this method has been enabled, the PIN (Personal Identification Number) of the VMG is shown
here. Enter this PIN in the configuration utility of the device you want to connect to using WPS.
The PIN is not necessary when you use WPS push-button method.
Click the Generate New PIN button to have the VMG create a new PIN.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
Table 25 Network Setting > Wireless > WPS (continued)
LABEL DESCRIPTION
Table 26 Network Setting > Wireless > WMM
LABEL DESCRIPTION
WMM of SSID1~4 Select On to have the VMG automatically give the wireless network (SSIDx) a priority level
according to the ToS value in the IP header of packets it sends. WMM QoS (Wifi MultiMedia
Quality of Service) gives high priority to voice and video, which makes them run more smoothly.
WMM
Automatic
Power Save
Delivery(APSD)
Select this option to extend the battery life of your mobile devices (especially useful for small
devices that are running multimedia applications). The VMG goes to sleep mode to save power
when it is not transmitting data. The AP buffers the packets sent to the VMG until the VMG
"wakes up". The VMG wakes up periodically to check for incoming data.
Note: This works only if the wireless device to which the VMG is connected also
supports this feature.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
