Chapter 1 Introducing the VMG
VMG3312-T20A User’s Guide
23
1.6.4 Using the WLAN and WPS Buttons
If the wireless network is turned off, press the WLAN button for more than two seconds. Once the WLAN
LED turns green, the wireless network is active.
You can also use the WPS button to quickly set up a secure wireless connection between the VMG and
a WPS-compatible client by adding one device at a time.
To activate WPS:
1 Make sure the POWER LED is on and not blinking.
2 Press the WPS button for more than five seconds and release it.
3 Press the WPS button on another WPS-enabled device within range of the VMG. The WPS LED flashes
orange while the VMG sets up a WPS connection with the other wireless device.
4 Once the connection is successfully made, the WPS LED shines orange.
To turn off the wireless network, press the WLAN button for more than two seconds. The WLAN LED turns
off when the wireless network is off.
1.6.5 Rear Panel
The following graphic displays the rear panel of the VMG.
Figure 11 VMG3312-T20A Rear Panel
Power
Button
Press the power button after the power cable is connected to start the
device.
USB The USB port is used for cellular WAN backup, file-sharing and media server.
Table 2 Side Panel Buttons (continued)
LABEL DESCRIPTION
To Next Page
Loading...
