Chapter 9 Routing
VMG3312-T20A User’s Guide
144
9.5.1 The RIP Screen
Click Network Setting > Routing > RIP to open the RIP screen.
Figure 69 RIP
The following table describes the labels in this screen.
Table 44 RIP
LABEL DESCRIPTION
# This is the index of the interface in which the RIP setting is used.
Interface This is the name of the interface in which the RIP setting is used.
Version The RIP version controls the format and the broadcasting method of the RIP packets that the
VMG sends (it recognizes both formats when receiving). RIP version 1 is universally supported but
RIP version 2 carries more information. RIP version 1 is probably adequate for most networks,
unless you have an unusual network topology.
Operation Select Passive to have the VMG update the routing table based on the RIP packets received
from neighbors but not advertise its route information to other routers in this interface.
Select Active to have the VMG advertise its route information and also listen for routing updates
from neighboring routers.
Enable Select the check box to activate the settings.
Disable Default
Gateway
Select the check box to set the VMG to not send the route information to the default gateway.
Apply Click Apply to save your changes back to the VMG.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
