Chapter 4 Tutorials
VMG3312-T20A User’s Guide
41
4.3.2 Using WPS
This section shows you how to set up a wireless network using WPS. It uses the VMG as the AP and Zyxel
NWD210N as the wireless client which connects to the notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter or
PCMCIA card).
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier of the two methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the VMG. A wireless client
must also use the same PIN in order to download the wireless network settings from the VMG.
Push Button Configuration (PBC)
1 Make sure that your VMG is turned on and your notebook is within the cover range of the wireless signal.
2 Make sure that you have installed the wireless client driver and utility in your notebook.
3 In the wireless client utility, go to the WPS setting page. Enable WPS and press the WPS button (Start or
WPS button).
4 Push and hold the WPS button located on the VMG’s front panel for more than 5 seconds. Alternatively,
you may log into VMG’s web configurator and go to the Network Setting > Wireless > WPS screen.
Enable the WPS function for method 1 and click Apply. Then click the WPS button.
Note: Your VMG has a WPS button located on the side of the device as well as a WPS button
in its configuration utility. Both buttons have exactly the same function: you can use one
or the other.
Note: It doesn’t matter which button is pressed first. You must press the second button within
two minutes of pressing the first one.
To Next Page
Loading...
