Chapter 11 Network Address Translation (NAT)
VMG3312-T20A User’s Guide
167
11.3 The Applications Screen
This screen provides a summary of all NAT applications and their configuration. In addition, this screen
allows you to create new applications and/or remove existing ones.
To access this screen, click Network Setting > NAT > Applications. The following screen appears.
Figure 82 Network Setting > NAT > Applications
The following table describes the labels in this screen.
Translation Start
Port
This shows the port number to which you want the VMG to translate the incoming port. For a
range of ports, enter the first number of the range to which you want the incoming ports
translated.
Translation End
Port
This shows the last port of the translated port range.
Server IP
Address
Enter the inside IP address of the virtual server here.
Protocol
Select the protocol supported by this virtual server. Choices are TCP, UDP, or TCP/UDP.
Wake up this
target by Wake
On Lan(WOL)
Select this to turn on the virtual server remotely.
MAC address of
WOL device
Enter the MAC address of the device to turn it on.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 57 Port Forwarding: Add/Edit (continued)
LABEL DESCRIPTION
Table 58 Network Setting > NAT > Applications
LABEL DESCRIPTION
Add New
Application
Click this to add a new NAT application rule.
# This is the index number of the entry.
Application
Forwarded
This field shows the type of application that the service forwards.
WAN Interface This field shows the WAN interface through which the service is forwarded.
Server IP
Address
This field displays the destination IP address for the service.
Modify Click the Delete icon to delete the rule.
To Next Page
Loading...
